<P>Bucket and breaker hammer, during the replacement process, due to the hydraulic pipe is easily contaminated, should be removed and installed as follows: the excavator moved to a plain non-muddy, dust and debris of the site,affordable advanced county asphalt paving machine market closed The engine releases the pressure in the hydraulic line and the gas in the mailbox.</P>
<P>Turn the stop valve attached to the end of the arm 90 degrees to the OFF position to prevent the hydraulic oil from flowing out. Will be broken hammer arm hose plug loosen, and then out of a small amount of hydraulic oil into a container. To prevent the soil and dust into the pipeline, plug the hose with a plug, with the internal thread plug the pipe block, in order to prevent dust pollution, high pressure pipe and low pressure pipe should be tied with a good wire.</P>
<P>Hose Plug: When equipped with a bucket,reinforced asphalt mixtures the plug is used to prevent dirt and dust from entering the hammer on the hammer. Internal thread plug: internal thread plug is to prevent the attached equipment in the host of dust or dust into the tubing. If you want to disassemble the hammer, you must first remove the pin connected to the pin; in the outdoor storage of broken hammer, should be placed on the sleepers and covered with thin Peng cloth.Vibratory Roller Prices
</P>
<P>If the hammer is not used for a long time, keep it clean: clean the outside of the hammer; remove the steel from the shell and apply the anti-corrosion oil. Before pushing the piston to the nitrogen chamber, Nitrogen sent; re-assembly, the hammer should be coated with various parts of the lubricating oil, and then assembled. If you want to install a hammer, the process is the same as the disassembly order mentioned earlier. If the bucket is operated, it is easy to get the hose and the end of the pipe to be contaminated,pavement crack repair method and the contaminated part is to be cleaned immediately (use hydraulic oil or diesel for cleaning).</P>