If the wall is not straight, draw the outline of wall line on the board, according to the line cutting plate, make it accord with the wall cleats wpc , each row of the last piece of board before the installation, should be 180.
Back to the rest of the board with the birch rod, on the behind as a marker, cut again after installation, so that we can ensure that the board shop is installed, with adjustable gap. In the end of the tongue, full amount evenly coated adhesive, with wooden cap composite pavers edmonton , hammer carefully connect panel, with a plumb line test whether balance, and placed in the wall between the plate and 8 ~ 10 mm of wooden mold.
Cut part of the first row of the last piece of plate, if more than 300 mm, can be used as the second row of the first board, if the first row of the last piece of board is less than 500 mm cleats wpc , it should be the first row of the first board part excision, ensure that the last piece of plate length is greater than 500 mm.