<p>ratio of 1:2 mixed into paste with a spatula, leveling, dry and then with sandpaper. The ground is smooth, clean, dry, can be spread. Gluing is the last working procedure before paving. Glue should be based on the size of the floor leather on the ground glue, coated with a piece of a shop, in order to carry out. At the juncture of leather should be kept 10 cm width not glue, in order to finally deal with joints. When the ground is coated with rubber hand touch feel </p>
<p>sticky after paving, put attention when using alignment line, with a long handle brush drive out gas and compaction. Floor joints are generally used to overlap the splicing method, the width of the overlap of about five cm is appropriate. The overlap is aligned with the center of long steel ruler, along with the cutter cutting board feet, and then remove the cutting edge under (note that there should be two strips, don't forget to take out the following one), with the amount </p>
<p>of glue to brush up brush the seams, then roll the seams are compacted. At the juncture of the extrusion of the rubber to clean, so as not to affect the appearance. And then use a thin layer of seam liquid along the seam. Finally, we should also check whether there are bubbles, whether the formation of. If there is a bubble, can be inserted into the air suction syringe, and then compacted. Finally, the use of detergent to clean the floor of the leather residue on the </p>
<p>malaysia outdoor wooden decking tiles<br />
best material for exterior stair treads<br />
custom wood plastic wall</p>